just picked up a mutation v3

[kingworm]

just picked up a mutation v3 and my god. that airflow. i have a darkhorse and it doesnt even compare. picked a authentic up at a shop for 40 and this is probably going to be my go to rda . any problems i should be aware of with this rda? got it set up with a six wrap 22g kanthal at .12 and its chuckin the vaper .

 

[TheVapingDevil]

I freaking love mine. Performance is through the roof

 

[Ngkon]

Love mine to, running it at .18 with a dual parallel 26 gauge build .

 

[kingworm]

what cap is that?

 

[Ngkon]

It's a V2 clone, it comes with the wide drip tip (shown) and an adapter to use a standard 510.

 

[dardios]

Hands down far and away my Authentic MXV3 is my go to. I've changed mods since getting it, but not my precious Atty. IDK if it will see a replacement anytime in the near future.

 

[Obsidian...]

The authentic comes with a chuff cap as well. The v2 clone is the same as the v3 authentic (they just replaced the stupid triangle set screws on the authentic) The clones always had phillips head screws. The clones chuffs are just a little larger (too large imho)

 

[kingworm]

i dont see a point in getting a clone mutation they are super cheap authentic and great quality so far .

 

[JOLT74]

i dont see a point in getting a clone mutation they are super cheap authentic and great quality so far .

I feel this way about almost all RDAs, mine are always authentic and I get them at my B&M for $30-45, I have tons and have thought I've over paid

 

[JOLT74]

Also you should get a chuff cap or the new glass domes they have for them now, those are cool

 

[kingworm]

ell i have the wide bore drip tip that came with it and already get plently of airflow... might go for the glass cap though

 

[Obsidian...]

My 26650 authentic v3 is shit... Unfortunately the authentics are *produced* by a clone company. Anyway, the top cap fits too tight and the fit to the deck is horribly loose (unfortunately). The main ring is also made from some very thin copper/alloy, unlike the tobh's. I love the Mutation X(s) but they failed big time on build quality and tolerances. I bought a copper one (which I had to pay more for and it doesn't come with the logo). So maybe it is just the copper version. Anyway it's going in the reject pile. Going to try out the fat buddha and see how that goes. If you get a clone I highly suggest picking up a Tebeco.

 

[scarecrowjenkins]

I bought the authentic copper v3 for $25 and i LOVE it. I do most of my building on it, no problems at all. There were a few changes above the v2, aside from the screws. The center post is wider to accommodate them and the air holes were drilled at an angle. I find the difference to be noticable