Become a Patron!

Kinda new to this, need some help with spitback and gurgling

Hey.
So I have bought a light e-cig not long ago, which I used until today because my new one arrived which is called: Joytech AIO Box. So this is the box edition, looks cool and all that. I did everything what I was told and before hand I asked around so I dont fk anything up. So now the problems. When I vape for more than 2-3 seconds with it it gurgles and spits a lot of liquid. It is fully new. Tried filling it half way, less or even just a little bit, nothing works. Cleaned the whole thing once or twice. Still does it. I mean I can vape but I cant hit it for more than 2-3 seconds because it literally feels like liquid is coming into my mouth. Its really bad. Can anyone help with this or have expreience with it ? Thanks in advance if so.
 

SirRichardRear

AKA Anthony Vapes on Youtube
VU Donator
Diamond Contributor
Member For 3 Years
Reviewer
Hey.
So I have bought a light e-cig not long ago, which I used until today because my new one arrived which is called: Joytech AIO Box. So this is the box edition, looks cool and all that. I did everything what I was told and before hand I asked around so I dont fk anything up. So now the problems. When I vape for more than 2-3 seconds with it it gurgles and spits a lot of liquid. It is fully new. Tried filling it half way, less or even just a little bit, nothing works. Cleaned the whole thing once or twice. Still does it. I mean I can vape but I cant hit it for more than 2-3 seconds because it literally feels like liquid is coming into my mouth. Its really bad. Can anyone help with this or have expreience with it ? Thanks in advance if so.
really not a lot you can do with a kit. usually spitback is from coils being flooded and the main solution to that is to turn up the wattage. but since that mod doesn't have adjustable wattage the only thing you can try is changing the coil out
 

HondaDavidson

Gold Contributor
Member For 4 Years
What is the PG/VG ratio of your juice? Might try a higher VG ratio. VG is thicker than PG and wick slower.
Increasing power output might also help.. but, Since you dont say anything about what you are using for an atomiser or coil. all I can suggest is try a lower ohm coil next. Lower ohm in your mod equals higher wattage.. Problem is lower OHM also usually means bigger coil and too much more power could increase the spitting. This may not solve the problem, could even worsen it, If the issue is your juice ratio or wicking.
 
I'm using the basic ones with the Joytech aio box, they are 0.6 Ohm coils. I think its good for now. I had it on charging for a couple of hours and now I only have gurgling after like slow 5-6 sec hits. Thanks for any help doe. If it keeps happening I will try out everything from here. I also use 50VG fluid.
 

Whiskey

Diamond Contributor
Member For 4 Years
Me thinks it's the coils, I went through a stretch where I had duds for a bit there, not that mod or tank, but it happens.
 

UncleRJ

Will write reviews for Beer!
Staff member
Senior Moderator
VU Donator
Platinum Contributor
Member For 4 Years
ECF Refugee
Reviewer
Moderator
Try applying power for a second or two before actually taking a hit.
 

Lefty

Silver Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
The coil is flooding. Take it outside and holding it upside down flick it with your wrist a couple of times to clear out the excess juice. Use the spiral drip tip and not the clear one. The AIO is a mouth to lung device meant to be used much like a cigarette. If you are drying to do direct lung hits i.e. drawing too hard on it it will be prone to flooding. A higher VG ratio juice can help.
 
Isnt VG more difficult for tanks like the one this has ? Shouldnt I use higher PG ratio juice ?

*Edited
Also, shouldnt I get 0.2 or 0.3 Ohm coils ? If you suggest me to do so, can you send me a site which delivers into eu ?
 

Lefty

Silver Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
Yes VG is thicker and if you were getting dry hits higher PG would help. Since your problem is over wicking or flooding then the thicker juice would help with that. No, the device isn't designed for 0.2 or 0.3 ohm coils. It may place too much stress on the built in battery and it doesn't really have the airflow to support such resistances if it could. The vape would likely be quite hot.
 

vapemesilly

Member For 4 Years
I keep saying this...the Joytech AIO are poorly designed units that spit juice. It isn't going to matter what kind of juice you use or how well the unit is charged or how many times you swap out coils. These things are crap. Buy something else. Life is too short.
 

gbalkam

Gold Contributor
Member For 4 Years
ECF Refugee
Reddit Exile
only thing I can think of, is if the cartridge isn't in just right and finger tight. Double check that everything is fitting straight into everything else (like no slanted threads) and try 70VG/30PG juice or higher VG content. 50/50 is more for the smaller cigalikes. Lower ohm coils tend to have larger juice holes, so a to thin juice might flood the coil. Everything else I think has been covered.
 

VU Sponsors

Top