Leaking Maus tank

[bittysue]

I have had the tank replaced by the shop that sold it to me, but both of them have just poured juice through the coil and out the air vents. I changed to a juice that is 80/20 vg/pg thinking perhaps my juice was too thin. I close the air vents when I fill (because it's a top fill tank). I upgraded my mod thinking perhaps the coil was just getting too wet from not enough power. It's been taken apart and put back together and it still leaks.
If I fill it over half full the juice will just run out until the tank is about half full. No one else seems to have this problem and I've had it now with 2 of these, so I'm guessing it's something I'm doing or not doing. Any suggestions?

 

[Huckleberried]

Sometimes I see a lot with certain tanks that it needs to be turned upside down after you close the top fill, BEFORE you open the airflow, let the juice from the base run down, then open the airflow. I don't know if that will help, but I suppose it's worth a shot.

 

[bittysue]

Sometimes I see a lot with certain tanks that it needs to be turned upside down after you close the top fill, BEFORE you open the airflow, let the juice from the base run down, then open the airflow. I don't know if that will help, but I suppose it's worth a shot.

I'll try it. It's seriously frustrating and wasteful to have your juice go everywhere. I've been just filling it half way and having to refill constantly. Might as well be using a dripper. lmao

 

[Huckleberried]

I'll try it. It's seriously frustrating and wasteful to have your juice go everywhere. I've been just filling it half way and having to refill constantly. Might as well be using a dripper. lmao

I agree, I know how frustrating that is. Some, I've just been done with, others just have little tricks to them. I hope this works out for you!