limitless Mod problems

[TasteMyToast]

So, I've been using mechanicals for about a month now, and recently decided to get a hybrid top cap mod. After a lot of research, I decided to get a limitless mod, and an authentic el cabron rda. First few days were awesome, thing hit hard, then a couple days ago the aluminum switch started getting some corrosion on it, where it touches the battery. Now it's misfiring, and not hitting hard at all. Cleaned the switch, and same thing. I'm getting really frustrated, anybody have any ideas about what I can do to fix this?

 

[cbrplume]

You clean all the connections? Make sure they all have a good connection as well?

 

[martinelias]

Get a meter.

 

[TasteMyToast]

You clean all the connections? Make sure they all have a good connection as well?

Yep, everything is clean. Everything seems to have a good connection. Dropped it off at the vape shop, their mech guy is going to check it out for me.

 

[cbrplume]

Yep, everything is clean. Everything seems to have a good connection. Dropped it off at the vape shop, their mech guy is going to check it out for me.

Awesome.

 

[Robert B]

Yep, everything is clean. Everything seems to have a good connection. Dropped it off at the vape shop, their mech guy is going to check it out for me.

What kind of battery are you using? And, did you drop off the atty too? could be a loose contact pin on the atty. There isn't much to go wrong with a mech

 

[TasteMyToast]

What kind of battery are you using? And, did you drop off the atty too? could be a loose contact pin on the atty. There isn't much to go wrong with a mech

I switch between samsungs and sonys. It's not the atty, because I'm using that atty on my other mech right now, working great.

 

[Robert B]

Have had almost the exact same thing happen before. It turned out to be a loose contact pin on the bottom of the atty. The post can't be loose, has to be snug. Would suggest to take the atty off and check that. It will rule out the atty as the problem for sure.

 

[TasteMyToast]

Have had almost the exact same thing happen before. It turned out to be a loose contact pin on the bottom of the atty. The post can't be loose, has to be snug. Would suggest to take the atty off and check that. It will rule out the atty as the problem for sure.

Turns out when I cleaned the aluminum off, it wasn't sitting flush with the battery anymore. They gave me a copper switch, and it's working great now.

 

[ticktock2085]

I have the Limitless LMC 200w mod with a uwell crown II tank. I picked it up one day and it said -Overtime-. It worked for a while but then read -Check Atomizer- . I replaced my coil but it still kept giving the -Check Atomizer- error. I tried the tank on another mod and it worked fine. It reads 9.99 ohm's. Can anyone help!?