Become a Patron!
Mutation x RTA
- Thread starter Bro2032
- Start date
I'm running mine with dual 8 wrap, 24ga 316 SS.. It comes in at .16 ohms. 44-48w @ 490° on my Rx200. Have a little leakage when I fill it (my sloppy wicking), but other than that I'm loving it.!!
Don't mind the screen.. That was another build I had in it..
Last edited:
I got the SS from eBay. It's 316L. They claim is profiled for 304, but I also run the Crown tank, and the coils are 316, and as you know, it's awesome on TC. So I figured I'd give it a whirl. I'm so glad I did. It's rough keeping the resistance up with 24 ga wire though. I'll use 26 ga next time..
My Rx200 doesn't like to TC the SS Crown coils, I hear they have Ni200 legs and that's why. Just doesn't shine like the Ni200 Crown coils do.
Meanwhile, still lovin' the Indulgence MT-RTA! Merry Christmas to me! I'm so fucking generous!
I did the firmware update, and the SS Crown coils are much better than the ni200.. I'm not sure if the update was the difference, but they are on point now.
Are you running the 1.08 fw..?
Yes..
It reads the resistance a little high, but it did before the update, and works great in spite of that. The crown coils usually read .27, and my meter, and other devices show them at .25. Doesn't seem to matter. I just lock it down, and vape..
I'm running it in that exact temp range with the 1.08fw.. I had one coil that came in at .26 ohm, and was hitting very weak. I went to wattage mode, and fired it one time which naturally raised the resistance. When it cooled down to .27 ohms, I locked it, and tried it. It worked perfectly.
I was getting some wonky resistance readings on my USA ohm meter, supposedly THE most accurate meter, on my IndulgenceRTA. Then I fired it up and loved the tank, until I noticed it was peeing joose. Checked the positive pin/post screw and found it to be factory stripped. Not really doing much of anything as far as securing the center post or sealing the atty. Sent a help message to VaporDNA but no response so far. Check the positive screw before you build. Back it out and pull the insulator, then see if it is engaging the positive post.
Got a very nice response from Joel at VaporDNA customer service about my Indulgence MT-RTA problem. They offered me a refund, store credit, or a replacement! I opted for a replacement, I like the tank. Very nice to get customer service from a company that cares. Kudos to VaporDNA, thanks Joel.
We'll see if the replacement tank has the same issues, I asked them to check it out before they mail it but that could be asking too much.
We'll see if the replacement tank has the same issues, I asked them to check it out before they mail it but that could be asking too much.
I like mutation RDA ld versions.
Finally built the replacement tank I received from VaporDNA and it work nicely. 3mm ID 26/36 Nichrome 80 dual claptons 5.5 wraps at .32 ohms. Nice vape, joose hog. Peed joose on the first fill but better on the second.