Hello everyone, i have an 26x2GA + 32GA Claton wire and i need help to figure out its ohms by lenght, we all know that wrap count or diameter makes no difference if the lenght of used wire is the same. I've seen on steam engine there's some calculators but i have no idea how to measure it. Maybe anyone could do it for me ?
P.S. My ohm tester and multimeter is dead. Ohm Tester shows bad ohms, jumps like crazy, lets say i screw it just a little bit tighter it jumps down to like 0.02ohms and if i losen it just slightly it goes up to like 5ohms. It even shows like 0.5ohms when there's no coils.
Also my target resistance is around 0.4ohm @ Dual or 0.8ohm per coil.
P.S. My ohm tester and multimeter is dead. Ohm Tester shows bad ohms, jumps like crazy, lets say i screw it just a little bit tighter it jumps down to like 0.02ohms and if i losen it just slightly it goes up to like 5ohms. It even shows like 0.5ohms when there's no coils.
Also my target resistance is around 0.4ohm @ Dual or 0.8ohm per coil.
Last edited:
