Need your thoughts

[vaping_in_dirty_jerz]

I want to do a twisted 24g or 26g with a flat ribbon wire wrap any ideas or experience with something along those lines I have worked with 24g exclusively for a while and started out working with 26g I know for some ribbon wrap builds the core wires were straighted and fused that way. Also would like to know what gauge ribbon should I get to try this build target resistance I was thinking would be like .25 ohms. Another question should it be a macro or a micro coil with this idea in my head

Sent from my VS985 4G using Tapatalk

 

[Neunerball]

There's a guy on YouTube by the name Twisted Messes. Look through his videos for coil build tutorials. If I remember correctly, he did some coil(s) with ribbon wire.

 

[vaping_in_dirty_jerz]

Yea I've seen a few of his I'll check them out when I get out of work the only I want to build something along these lines is because I want to hone my build skills you know and it seems like it would be a nasty build. But then again it could end up blowing up in my face but yea

Sent from my VS985 4G using Tapatalk

 

[Neunerball]

If you are building coils, in order to be used on a mech mod, you should know Ohm's law, and have an ohm meter, to check your build for shorts and resistance, before putting it on a mod.

If you know the name of the build you're looking for, Google is your friend.

 

[vaping_in_dirty_jerz]

Yes I know all about it I use a smok m80 plus 80 watts with temp and mech modes as well

Sent from my VS985 4G using Tapatalk