Hi all, am looking for some advice. I am trying to get into RDA building and I am having a little issue. I have purchased a drop RDA which I like the idea of and I believe it is ok to build for a new person. I have purchased some pre-made 0.3-ohm coils, so was thinking dual coil 0.15 resistance would be nice. This is where I get a bit lost, I am placing my coils in the RDA, then cutting the leg where I think the right place is, but when I cut and check resistance it is below 1 ohm or just on 1 ohm. All I can put it down too is the length I leave of the coil leg, But am sure I am cutting them in the right place. Any advice is great. Thank you