Hello, I am facing am issue.
I put in a dual pre wrapped kanthal and nichrome clapton on a new hannya rda authentic, the ohm reader read it at 0.22 I put in on the device started firing an pinching etc to make the coil fire equally, I had difficulty with that I thought it was from the coils so I replaced them. I put in new dual kanthal and nichrome same build as last time, the ohm meter reading it as 0.0, I wrapped a 26g 11 wrap just to see if it was from the coils, the ohm reader read it as 0.0, I put back the clapton, ohm meter read it as 0.0 again, I put it on my segeili 150 tc, the device read it as 0.24 then jumped to 0.26 and I'm vaping on it but I don't feel comfortable doing so.
I would really appreciate some tips and suggestions.
Thank you very much
** ohm meter battery is new, I screwed on my velocity it reads .21
I put in a dual pre wrapped kanthal and nichrome clapton on a new hannya rda authentic, the ohm reader read it at 0.22 I put in on the device started firing an pinching etc to make the coil fire equally, I had difficulty with that I thought it was from the coils so I replaced them. I put in new dual kanthal and nichrome same build as last time, the ohm meter reading it as 0.0, I wrapped a 26g 11 wrap just to see if it was from the coils, the ohm reader read it as 0.0, I put back the clapton, ohm meter read it as 0.0 again, I put it on my segeili 150 tc, the device read it as 0.24 then jumped to 0.26 and I'm vaping on it but I don't feel comfortable doing so.
I would really appreciate some tips and suggestions.
Thank you very much
** ohm meter battery is new, I screwed on my velocity it reads .21
Last edited:
