I took a jig saw mounted a 1 1/4 inch threaded reducer PVC pipe fitting and a hose clamp to hold threaded end on blade then cut a short peice of pipe to fit had to close pipe some by splitting longways then glued.
Mounted saw upside down on work table by drilling base of saw and attaching with screws make sure saw is on low speed, after you warm your Eliquids put in and couple minutes it will look like foam in bottle..
Also pluged in to a switch I could turn on and off easy.
Mounted saw upside down on work table by drilling base of saw and attaching with screws make sure saw is on low speed, after you warm your Eliquids put in and couple minutes it will look like foam in bottle..
Also pluged in to a switch I could turn on and off easy.
