I have an ITASE MVP while at a local vape shop today I was told that I could drip on my box mod at something around 1.2 ohm, my first question would be is this possible? Naturally out of curiosity I used a coil builder app with the following info 26ga Kanthall A1 with a 3mm id. and 9 wraps would but the ohms at 1.18. if this is possible would this have improved flavor over the nautilus that current use until my 70w box gets here.
Become a Patron!
RDA on a MVP
- Thread starter nodens86
- Start date
anendeloflorien
Silver Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
You definitely can do a mid-range (1.2-1.5 ohm) build for that box! You might also enjoy the kanger subtank mini, with the 1.2 ohm coil it gives a really nice clean vape and then when you get your higher wattage box you can switch to the 0.5 ohm coil and/or use the rebuildable deck to make whatever you want!
martinelias
Silver Contributor
Silver Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Should be better. Remember mvp has a 3amp battery and 1.18 is right on the border.
Cloudboss
Bronze Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
since the mvp is lower wattage you will need to build with a really thin kanthal like 30 or 32 guage and i would sugest a single coil because the ramp up time on a dual at 12 watts would be forever. if you have the 30 watt version you could parobably do a dual coil
@Cloudboss is correct. You will need to run 28 or thinner and a single coil only.