Become a Patron!

RDA with IPV D2 (some questions)

Hello, just signed up here. I have an IPV D2 with a Sense Herakles Tank with the .6 ohm coils. I'm interested in getting into RDAs and I have NEVER made my own coils before. The RDA I want is a Lone Wulf RDA in Copper. As I was looking for tools needed for RDAs I saw that I needed to purchase an OHM reader. My question is, my IPV D2 reads ohms so would I need to still buy an Ohm Reader? I plan on making builds between .2-.4 ohms (since the IPV D2 only reads down to .2) and I am also wondering if it is safe for me to use an RDA with my IPV D2? Here is the link on what I plan to do with my coils.
. Also what watts would you run at with a .2-.4 ohm build? I go up to 60-75w with my .6 since I use max vg 0 nic juice but I was wondering if those watts are necessary with an RDA with the .2-.4 build? I have an IMREN IMR 3500mah 30A battery. Thanks so much I know I asked a lot of questions.
 

VapeRN

Bronze Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
You're probably gonna need every bit of power out of that device to run at .2. I'd stay closer to .4 and you should be able to get away with 60-75w. Grimm's build in that video is fine, just use steam engine to pre calculate your ohms and you can use your device to check the reading. A 9$ ohm reader is probably not going to be much more accurate. The battery is fine in a regulated device, just treat it like a 20A which is really what is probably is at best.


Sent from my iPhone using Tapatalk
 

VU Sponsors

Top