Royal Hunter RDA Voltage&Ohm Jumps

[brianh54]

Hi, been a while since I posted, but I need help!

I recently purchased a new Royal Hunter RDA at a B&M, and I'm using a 22g (6 wrap the first time, 7 wrap the next) and it's getting a higher Ohm rating and the voltage on my sig100w keeps jumping. Not only that, but when I put it on my iStick50w, it keeps going 0.2Ohms/3.2V to 0.3Ohm/3.8V like a glitch and the iStick screen keeps jumping back and forth (it is no longer on my 50w, but on my 100w). I've tightened the screws for the contact (one seems to be loose on the ground post, but I swapped it out numerous times), and it jumps, but when I unscrew the RDA and screw it back on, voila! My resistance is back to .2 ohms.

Can anyone tell me why this is? Should I do more wraps or use a lesser gauge wire?

EDIT: I've also tried messing with the 510 connector to see if it just needs to be out while connected, but it didn't work as well.

 

[Huckleberried]

Moved to General Rebuildables for some help.

 

[LuTang]

i had this happen on my velocity clone. are you sure your 510 connection on your atty is tight? on a vid i watched, it said the 510 was adjustable so i loosened it so it would protrude a little more for using on a hybrid mod. when i put it on my istick 50w it was jumping up and down kinda like what you're describing. turns out, my clone version is not adjustable so the connection wasn't sound. i tightened the 510 on the atty and it hasn't jumped since. hopefully this solves your problem. good luck!

 

[Dawn0810]

Sometimes if the coils aren't completely together the ohms will jump like that.


Sent from my iPhone using Tapatalk