Hi Guys,
Currently working with an IPV 4 and a vector rda.
I have noticed that 2x now (once when building and once when trying to clean the coils), that a small piece of actual nickel wire has broken off and luckily I found it (due to my ocd) and removed it before using.
One time I was rewicking after cleaning the coils and I looked real hard and found this small piece of wire that had broken off the center post on my dual coil when re tightening it up.
Had I not actually looked and found it and removed it with tweezers I almost certainly would have inhaled a tiny piece of actual nickel wire, which I imagine would be disastrous.
Anyone else have experience or ideas about this??
Thanks.
Currently working with an IPV 4 and a vector rda.
I have noticed that 2x now (once when building and once when trying to clean the coils), that a small piece of actual nickel wire has broken off and luckily I found it (due to my ocd) and removed it before using.
One time I was rewicking after cleaning the coils and I looked real hard and found this small piece of wire that had broken off the center post on my dual coil when re tightening it up.
Had I not actually looked and found it and removed it with tweezers I almost certainly would have inhaled a tiny piece of actual nickel wire, which I imagine would be disastrous.
Anyone else have experience or ideas about this??
Thanks.
