hi i have been using this setup for a little over a month and its been great.i started getting burnt hits so i change the coil and started getting juice in my mouth bad. i tried another coil(yes i primed them first) and same result. is it possible that the tank is just bad or could it be something else please help with any suggestions thanks
Become a Patron!
smok m80 pro with arctic tank-getting juice in my mouth
- Thread starter btkiller11111
- Start date
somebodies got to know...why would u get a mouth full of liquid every pull with new coils
fuck this forum..im the only person that ever had this problem before...i doubt it..waist of my time
xlowxyotax88x
Member For 4 Years
Way to be childish man....
Sent from my LGLS740 using Tapatalk
Sent from my LGLS740 using Tapatalk
Waste of your time? Lol .
I see your only 24yrs old and only posted 3 times....chill out....don't
get all excited because noboby has replied to your problem yet..you won't find any better help than that's available on this forum.. Lots of good folks here that are ready to help if you have a little patience.....
That said, the first thing I do after pulling the old coil is use a q-tip to clean the base where the coil srews in....make sure the gasket(s) on the new coil are not missing and seated where they should be...screw in the new coil tightly by hand..prime it with a few drops, fill the tank and put it together.. I take a few pulls without firing the mod, then start low and bump up to my desired sweet spot which is about 60w with the .2 coil
Good Vapor and flavor..cloud is typical I get with the Arctic..
Arctic seen here on my black IPV3 has been good..no leaks or spitback in the
3 mos I've been vaping it...later dude
sent from my XT1080 via Tapatalk
thank you for your help and i guess i jumped the gun but alcohol and frustration does that to ya sometimes lol thanks againWaste of your time? Lol .
I see your only 24yrs old and only posted 3 times....chill out....don't
get all excited because noboby has replied to your problem yet..you won't find any better help than that's available on this forum.. Lots of good folks here that are ready to help if you have a little patience.....
That said, the first thing I do after pulling the old coil is use a q-tip to clean the base where the coil srews in....make sure the gasket(s) on the new coil are not missing and seated where they should be...screw in the new coil tightly by hand..prime it with a few drops, fill the tank and put it together.. I take a few pulls without firing the mod, then start low and bump up to my desired sweet spot which is about 60w with the .2 coil
Good Vapor and flavor..cloud is typical I get with the Arctic..
Arctic seen here on my black IPV3 has been good..no leaks or spitback in the
3 mos I've been vaping it...later dude
sent from my XT1080 via Tapatalk
xlowxyotax88x
Member For 4 Years
I dont have an artic but ive had my atlantis v2 do it wen i carelessly fill it and juice gets inside the coil couple of hard pulls later its gone. As smacksy said a good clean will probably do the trick
Sent from my LGLS740 using Tapatalk
Sent from my LGLS740 using Tapatalk
Pauly Walnuts
Gold Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Member For 5 Years
Do you mean solid juice, or that it spits lots of little droplets?
It comes out pretty heavy
Yes i had a. 5 in and thats what leaked... I switched to a. 2 since then and it seems to work fine now