smok tfv4 rba spitting

[tommy199500]

Hi all
New to this site
Have got a smok xcube two with a smok tfv4 tank been using the quad coils just thought I would try the rba
It has a twisted coil running at 0.53 ohms
It is spitting a serious amount of juice into my mouth
What's the highest watt I can run it at
Any advise would be helpful as I am new to this rba thing
Thanks alot guys hope to hear from someone

 

[Faceless Vapes]

What type of wicking method are you using?

Post some pics of the wicked build.

 

[logan deters]

I use the quad coil and it also spit up alot of juice can anyone tell my why

 

[smacksy]

I use the quad coil and it also spit up alot of juice can anyone tell my why

Maybe not enough power to vaporize all the juice in the cotton wick..that said I ran my quad at about 90w before it quit gurgling/spitback...I pulled that coil because like the triple better...

Sent from my XT1080 using Tapatalk

 

[tommy199500]

What type of wicking method are you using?

Post some pics of the wicked build.

Bought it of a friend and he built the rba with a twisted coil wick though the middle

 

[tommy199500]

How do I attach a photo

 

[Faceless Vapes]

Should be an image button

Sent from my SAMSUNG-SM-G900A using Tapatalk

 

[tommy199500]

Let me know if you can see it

 

[VAPEROXX]

Let me know if you can see it

Doesn't look like enough cotton to me. I use the dual coil RBA at .4 ohms 42 watts and no spitting issue.

 

[tommy199500]

Do you have any pictures of yours or one like mine so I have an idea how much cotton and what watt would I be able to go up to do you think
Might just go back to the quad coil so much easier just not that much taste

 

[Flightmedic76]

I agree, the wicking looks too light. The left side is not touching the coil on top. When wicking there should be some tension when it is pulled through. General rule of thumb is to cut the wicking roughly twice the diameter of the coil. Also be sure the wicking is sitting in the juice channels properly. Too much and it will not wick well. Too little and the chamber will overfill which can cause leaking into the airflow chamber.

 

[tommy199500]

Iv just wrapped a new coil using kanthal a1 24 gauge and it's jumped up to 0.7ohms how do I get a lower restance was hoping around 0.1-0.2ohms

 

[Flightmedic76]

Not sure I'd go that low with Kanthal on a tank, but everyone has a different opinion. The steam engine link below will help with coil wrapping, DIY e-juice etc.

http://www.steam-engine.org/coil.asp?r=0.7&awg=25&id=3

 

[iSubOhm]

Iv just wrapped a new coil using kanthal a1 24 gauge and it's jumped up to 0.7ohms how do I get a lower restance was hoping around 0.1-0.2ohms

I would take it a bit higher. Try to hit .3. Tell me your inner diameter and how many wraps your coil

Calls To Action! casaa.org