Smok Xcube 2 question

[stormyseas]

Anyone who owns an X cube !!! how do you lower the resistance ??
I keep on getting the " check atomizer " warning .
Any help would be great .
I am missing using this motha

 

[Bean8379]

If you're referring to temp control, based on what I've read the xcube 2 has problems with tc. Wires used for temp control have no resistance, the chip controls the temperature by heating up the wire. If you are referring to power mode, you lower the resistance by building a different coil. You can adjust the power up or down by reading the manual and learning how, or at least I would assume.

 

[stormyseas]

thanx , that is what i thought but can not find anything in the manual about adjusting .
I am using the Smok TFV4 atomizer , I don't do RDA

 

[stormyseas]

hey there Jim ,
i keep on getting a prompt on the cube stating " check atomizer" in the manual is explains that the cube does not have an atomizer attached or that the resistance is higher than 10 ohms .
I also have a eleaf 100w and the atomizer works on that ,so by that i gather that the problem is with the cube .
I am quite new to this and don't really understand that much about this problem .
regard
shane

 

[stormyseas]

hey there Jim ,
i keep on getting a prompt on the cube stating " check atomizer" in the manual is explains that the cube does not have an atomizer attached or that the resistance is higher than 10 ohms .
I also have a eleaf 100w and the atomizer works on that ,so by that i gather that the problem is with the cube .
I am quite new to this and don't really understand that much about this problem .
regard
shane

I was curious which factory head(s) was giving you trouble.

But a high ohm error is generally either some connection is not tight or a coil leg is damaged/cracking/snapped. Having it work on the i100 however...
If it's an issue with the Cube, trying another tank will help confirm that.
Basically... we need more data to determine where to focus.

TEST ALL THE THINGS!

i have two TFV4 tanks I have one with the triple goil and the other with the sextuple coil both not working on the cube but do on the eleaf .

 

[stormyseas]

Morning Jim ,
Thanx for your help ,

But a high ohm error is generally either some connection is not tight

this sparked a thought of pulling the tank to pieces and cleaning and reassembling (for the second time ) and yep it is working
. t
The strange thing being that both tanks went at the same time .
Thanks to you ! i am back happily vaping with the cube ( my favourite mod , as it really does flavour great ) and all is
good in my world again .
cheers
Stormy