Become a Patron!

Sometimes clouds are thick sometimes clouds are thin what do I do?

I'm new to vaping and I bought a raptor t6 mod paired with a fuel rda. The mod has copper connections and I'm using it with a Samsung 25r. I have dual coils on a .50g kanthal on my rda. I've noticed that sometimes I can pull huge clouds from it and after a few pulls the clouds seem to get thinner and thinner with every pull. Can someone please explain this to me. What am I doing wrong and what should I do to keep the clouds thick, thanks!
 
I tried that a lot of times but it doesn't seem to make a difference. I only get a few good pulls of thick clouds and after that it's thin clounds all the way. Thank you, do you have any other advice?
 

eSMOKA

Silver Contributor
Member For 5 Years
I don't exactly know the wattage as I am new to this, but the Atty has four airholes and all of them are wide open.

I mean no offense, but if you are new and you are not paying attention to wattage and amperage, then you should not be using a mech yet.

Sounds to me like it may be possible your mod's voltage drop is somehow increasing as you take hits. Possibly due to shiffy parts or craftsmanship. Just a thought.
 

wally

Gold Contributor
Member For 4 Years
ECF Refugee
Really they should take mech off the market just to many people don't know what they are doing. Also vape can be better at times because of moisture conditions. The weather has a lot to do with it.
 

wally

Gold Contributor
Member For 4 Years
ECF Refugee
Here yesterday truck driver crashed because he was vaping a mech it blew up in his face caused him to run off the road I don't think anyone else was hurt. He got his face blown off bad.
 

Neunerball

Platinum Contributor
Member For 4 Years
Member For 3 Years
ECF Refugee
Did he just say .50 kanthal??? Wtf ?


VAPE ON
I'm assuming he's talking about 0.50mm Kanthal, which is like a 24g. The bigger question though is the resistance of the coil(s). The mech mod the OP is using is a dual 18650 parallel box mod. Therefore, the possible continuous discharge rate would be at 44A. However, if the resistance of the coil(s) is very low, the batteries would be drained quickly. Therefore no big clouds.
 

pescadore

Silver Contributor
Member For 4 Years
Your choice of mods as a beginner was not the best. It makes me so mad that there are shops that push mech mods on beginners. I would advise that you buy a regulated mod of some kind with a good tank that uses pre-made coils. What you are using could be potentially dangerous. I have never heard of .50g Kanthal but would be curious to know what resistance you are running with the dual coils. I am assuming that you bought the setup at a vape store and I would recommend that you take it back and let them check it out to make sure you are vaping safely. I am not trying to belittle you in any way, just trying to help. We all were beginners at one time and sounds like you just got some bad advice on what to buy.
 

ej1024

VU Donator
Diamond Contributor
Member For 4 Years
Geeezuz, you pushing ur battery to the limit dude...
Boom


VAPE ON
 

ej1024

VU Donator
Diamond Contributor
Member For 4 Years
If you wanna keep it thick
Buy a regulated box mod!!!
Obviously you don't have any idea how vaping works, I'm sorry guys but I can't stand stupidity...being 19 years old I'm assuming ur at ur moms garage playing cloudzzz....


VAPE ON
 

VU Sponsors

Top