Spinning Center Post

[TylerDurden]

Hello fellow vapers! This is my first post so here we go. Most RDAs I purchase have this issue. I was hoping that you could suggest some RDAs that don't do this. Preferably clones or lower price authentics. Thanks for reading.

 

[State O' Flux]

If you look at RDAs with "tightenable" center posts, like an Origen V2 or Faceless Veritas, for a few examples... it's a non-issue. It's the pressed-in posts that (with no easy method of increasing tension or torque), if you go too far beyond "snug" when tightening the screw... you're hosed.

 

[nightshard]

In some cases, the center post is held in place by the same screw that also functions as the 510 pin.
This means that in this case the pin is not adjustable.
The solution to prevent spinning to tighten the 510 pin.

 

[Jah]

The doge v2 has a square center pin, i believe the dark horse does as well, square dont spin 8)

 

[DustinB]

The only one I've ever had spin on me was a tobeco magma clone. It had the pressed in posts and one was loose. Switched it out for another and had no problem.

 

[TRIPDUBZ]

The doge v2 has a square center pin, i believe the dark horse does as well, square dont spin 8)

My buddy has an auth dark horse and he said the center post spins like crazy...

 

[Sully]

My buddy has an auth dark horse and he said the center post spins like crazy...

So do the clones...Authentic Mutation X V2 or V3 can be found for less than $30 and do not have this issue.

 

[Oggy]

I have a troll and freakshow both by WOTOFO and have had no issues. I run the low sub-ohm builds on the troll and have no issues with the posts. $23 for wither at Triangle Vape. http://trianglevape.com/troll-rda-wotofo/

 

[OBDave]

I've had this problem to some extent or another on just about every clone I've ever owned, with the exception of the Mutation X2 and the Igo-M...

 

[Anus Braun]

I was ignorant, and 'RDA-struck' enough, to shell out thirty fer a Mutation X V2...I will say it's quite well-made, works well...and NO LOGO.

 

[Neunerball]

I was ignorant, and 'RDA-struck' enough, to shell out thirty fer a Mutation X V2...I will say it's quite well-made, works well...and NO LOGO.

If I would buy a Mutation X, I'd go with the V3 though.

 

[Rhyno636]

Lethal rda won't spin.

 

[tcmx250]

Have the same problem with me tobh atty, due to the 510 post needing to be adjusted down lower to hit the copper positive pin in my mod, the center poat spins.