Become a Patron!

Stainless Steel Fused Clapton in a Mech??

Woodsman

Woodsman

Silver Contributor
Member For 4 Years
Anyone do this? I copied this from a seller:

THESE COILS ARE FOR ADVANCED BUILDERS ONLY!! STAINLESS STEEL WIRE/COILS ARE FOR USE IN REGULATED AND/OR TEMPERATURE CONTROLLED DEVICES ONLY, AND NEVER IN UNREGULATED/ MECHANICAL MODS! YOU MUST HAVE THE ABILITY AND UNDERSTANDING TO INSTALL AND REMOVE SHORTS/ HOTSPOTS FROM THE COILS. STAINLESS STEEL HEATS UP FASTER AND AT MUCH LOWER VOLTAGE (ROUGHLY IN THE 2- 3 VOLT RANGE) THAN KANTHAL! YOU WILL NOT GET AN ACCURATE OHM READING UNTIL ALL HOTSPOTS ARE REMOVED UPON INSTALLATION. DO NOT ORDER THESE COILS IF YOU ARE NOT CONFIDENT IN YOUR ABILITY TO REMOVE HOTSPOTS!!!!
 
anen

anen

Silver Contributor
Member For 3 Years
Member For 2 Years
Stainless works fine on tubes and parallels, should be good even on series but I didn't try yet.
 
BigNasty

BigNasty

Diamond Contributor
Member For 4 Years
ECF Refugee
Even with all the testing set ups and line meters... not a chance in hell.
I value my flesh.
 
R3alJim Shady

R3alJim Shady

Platinum Contributor
Member For 4 Years
I run a single 34g/26g fused Clapton that ohms out to .36. Works just fine for me and flavor is awesome. For dualies, I use 28g instead. Comes out to .2 ohms. So long as you're using quality batteries everything should be fine.


Sent from my iPhone using Tapatalk
 
Zamazam

Zamazam

Evil Vulcan's do it with Logic
VU Donator
Platinum Contributor
Member For 5 Years
I vape dual ss claptons at .17Ohms in a mech with a VTC4. Work fine.
 
joeyboy

joeyboy

Gold Contributor
Member For 5 Years
jmoney426 said:
I run a single 34g/26g fused Clapton that ohms out to .36. Works just fine for me and flavor is awesome. For dualies, I use 28g instead. Comes out to .2 ohms. So long as you're using quality batteries everything should be fine.


Sent from my iPhone using Tapatalk
Click to expand...
Is that 28g dual SS?
 
You must log in or register to reply here.

VU Sponsors

Top