These RDA's ok

[chris.ardito.3]

I have the freakshow, Royal hunter mini, Mutation xs mini. Which one of there are ok with the noisy cricket?


Sent from my iPhone using Tapatalk

 

[PaulS]

Any one of those as long as you build above .4 ohm. It is the build you have to watch on the cricket.

 

[Whiskey]

Moved to RDA section

 

[DED420]

The Noisy Cricket Mod has a Hybrid top, therefore Positive Pins and 510 Threads are your largest concern. The Mutation XS Mini and the Royal Hunter Mini are OK to use, with an appropriate series build. The Freakshow is iffy. It will depend on the Positive Pin. The Mutation and RH have adjustable Positive Pins, whereas the Freakshow does not. I know some clones have longer/shorter 510 threads and positive pins, so it will be determinate on which one you have. Just check your Positive Pins on all the RDAs and make sure the Positive Pin is protruding far enough from the 510 threads, and they should be fine to use (again, with an appropriate series build).

 

[Neunerball]

Any one of those as long as you build above .4 ohm. It is the build you have to watch on the cricket.

I have a 0.7 Ohm dual coil build. However, even that is almost too hot for me.

 

[r055co]

- snip -
The Freakshow is iffy. It will depend on the Positive Pin.
- snip -

I've been sporting my Freakshow with the Chuff Cap on my Cricket @ .8 build with fused claptons. Very nice flavor and awesome vapor production (of course, it's the Noisy Cricket).

As for the pin, it does extend enough, but then again I also use Heat Sinks which even protrude the pin even further.

 

[raymo2u]

I built the Freakshow and MX4 for the NC...Its a decent vape, I would recommend building in the .5 range with as they burn right through the juice due to the smaller juice wells they have...