Ti and SS coils

[drugarth]

Hi,

Just got a new mod which also takes SS and Ti wire. But got no clue to which ohm I should build for TC and if they need to be spaced for TC. Also: can they be dry burned?
Ni200 I usually build to 0.2ohm, but not sure what to use for these wires...any1 can give me some starter points?

 

[drugarth]

Got myself a dani extreme v2+ it's very nice , also upgraded my sx mini so now it also takes Ti and SS

I indeed use the steam engine page to calculate my coils....but I am not sure what a recommended resistance is for these wires and TC...is 0.2 ohm good?

 

[AZ_Shooter]

You can space your Ti coils. No pulse/tweeze •required•...

 

[CurlyxCracker]

Both can be contact although at least for my X Cube II & Evic (for Ti) I find spaced work better for staying in temperature control mode and more consistent temp control. I go around 0.4 +- 0.2 ohms for ti and roughly what I would use for kanthal for SS. SS at least 316L 24 awg heats up quickly. I use SS for both TC and Power modes as well depending on mod/vaping style I'm looking for.

 

[drugarth]

super! thanks for the answers...I'll be trying me some builds..think I'll go for 0.4ohm and see what happens thanks again!