Titanium 1 zipper no temp control

[jameswatkins2nd]

So I made a 28g titanium zipper to run on temp mod on my IPV3 LI it has been updated and runs up to 100j I have temp normally set at the max on a single 8 wrap t1 coil. So where am I making a mistake? The post are all tight good connections am I missing something? Its 0.61 ohms

Sent from my SM-N900V using Tapatalk

 

[Zamazam]

Try reading it on your Ohm Meter.

 

[jameswatkins2nd]

It is now breaking in at 0.14 Ω but that still does not answer why it will not properly work on temp control.

Sent from my SM-N900V using Tapatalk

 

[jameswatkins2nd]

Does the ipv3 li have a limit on the ohm it can perform at on tc? Now it just says dry wick in tc with the wick a full saturation. I can Vape in power mode

Sent from my SM-N900V using Tapatalk

 

[BigNasty]

Check your connections maybe?

 

[jameswatkins2nd]

Check your connections maybe?

Thanks maybe did something wrong I am new to tc but I want to get involved it is the future! I removed the coil and replaced it with a single coil 8 wrap 28g titanium 1 the tc never kicked on it just burned like crazy perhaps I broke it

Sent from my SM-N900V using Tapatalk

 

[BigNasty]

something is not working right.
I am not into the tc but abide by the theory of check the basics first.
Connections, battery, software.

 

[Zamazam]

Does the ipv3 li have a limit on the ohm it can perform at on tc? Now it just says dry wick in tc with the wick a full saturation. I can Vape in power mode
,
Sent from my SM-N900V using Tapatalk

I suspect the load of all that wire than needs to be heated is kicking the mod out of TC. With a coil of single strand wire, less energy is needed to heat it to temperature vs a clapton/zipper coil. You may be hitting an internal current limiter in the mods program.

 

[jameswatkins2nd]

I suspect the load of all that wire than needs to be heated is kicking the mod out of TC. With a coil of single strand wire, less energy is needed to heat it to temperature vs a clapton/zipper coil. You may be hitting an internal current limiter in the mods program.

I think you are right. Even with single coil builds with 26g titanium I am getting dry warnings and misfires at first I thought I had broken it but I have discovered how delicate the connection is with this titanium wire. My screws back off or wears down. I just need some time to get my skills built up on tc.

Sent from my SM-N900V using Tapatalk