Tugboat V2 build questions

[robbh47]

So I bought a tugboat v2 RDA and am planning on a dual coil build. I also have pre made tiger coils (26gauge 0.8 flat 0.2), and I'll be running the set up on an Eleaf Istick 100w.
Questions!

Q1: will I need to drill out my centre post for the two coils.
Q2: would you recommend drilling out the air holes too ? (They seem small)
Q3: is there any advantage to staggering my coils up and down or should they both sit level?
Q4: the pre made coils apparently measure 0.36ohms, will this vary from device to device ?

P.S still a noobie so any help is much appreciated.
Regards , robb

 

[Jah]

Q1: its been a while since i traded off my Tug v2, if I remember right, the center post hole should be fine
Q2: I drilled out the air holes in my Tug1, the v2 seemed just right for me
Q3: If I am understanding you correctly, keep both coils level and at the same height as the air holes
Q4: There may be some varience between devices as to what it reports the Ohms at, but on the whole, they should remain stable and vary little

 

[robbh47]

Like in a tank the coils need to be replaced, presumably in an RDA the coils need to be replaced? How long would a setup last in an RDA on average?

 

[Jah]

the coils can be stretched out to months easily. The wicking material would need to be replaced 1-7ish days depending on the type of juice you use/amount of power applied/etc. When you rewick, just dry-burn the coils to get rid of any crud that accumulates on them