why does not rx2/3 go over 54W with the troll RTA

[flykick]

My rx 2/3 does not go higher than 54W with my new troll RTA. It did before, so i wonder why. I understand it has something to do with automated regulator in resistance, or something like that, but it should go higher than just 54. Something is off, and i like to know how i fix it. I have the premade coils that came with it

 

[flykick]

now it just go down again to 46... and no, my battery is not low

 

[Angrygod50]

It depends on the resistance. If your out of the sweet spot the mod will throttle back the power. What resistance are you running?

 

[fraleywp]

Do you have a non-Wismec mod you can try it on? It could be misreading the ohms, or your ohms are out of range.

 

[HondaDavidson]

You do have GOOD fully charged batteries...

Ohm mode and other mod setings might help.... particulars if build and how you are running it are minimum requirement to getting any real help.

Too me sounds like bad or dead batteries or resistance too high or too low... thinking too high as the mod should error on low ohm issues.

Sent from my SCH-I605 using Tapatalk

 

[flykick]

i have the troll rta tank, with the standard coils that came with... How do i change the resistance on the wismec then?? Couse when i fire up my big baby beast nothing is weird

 

[Angrygod50]

DON'T change the wattage on the mod. The resistance is determined by the coil. What resistance is the mod showing?

 

[flykick]

Thats weird, it showing different resistence everytime i put it on... thats weird. Just now it was 0.83, then 0.82, then before it was 0.5 something... what the fuck does that mean? thats probably why it changes the top watt i can use every time... and i have to stress that i bought the wistec mod yesterday and the troll rta today. Why does this happen??

 

[flykick]

i think i finally figured out the problem... i read somewhere else that the ohm can change if you dont tighten the screws on the coils, so i checked them and found that they were in fact very loose. after tightning them i now get an ohm of 0,3, and its not changing anymore... so thats awesome... Thanks for trying to help me guys... vape on