I'm not familiar with the Snow wolf in person, but from your description, it sounds as if itshows live resistance readings even in TC mode. Nickel wire increases in resistance as it heats up, that is in fact how TC mods function.I have an Artic nickel coil .2ohm on a snow wolf. The temperature is set at 450 degrees F. When I first hit the tank it shows a .26 ohm (set at between 60-70w) and after I'm done pulling it shows .58 ohm. Any idea why the ohms are increasing after I hit it?
I'm about to pick up an Arctic Tank, and plan on getting some Nickel coils. How are they working out?
Yeah, I'm gonna have to order a pack. I dig the tank, though, I'm getting some spit back. No leaking. I'm using .2 BTDC's. It seems to taste a bit off, but after a couple tanks, it's better, and I'm not used to cotton. I chain vaped an entire tank in about 15 minutes, and got all sweaty from the nic. The thing is unreal, really drinks juice, though.Ditto. I just got the arctic and love it but would like to use the TC function on my DNA40
Yeah, I'm gonna have to order a pack. I dig the tank, though, I'm getting some spit back. No leaking. I'm using .2 BTDC's. It seems to taste a bit off, but after a couple tanks, it's better, and I'm not used to cotton. I chain vaped an entire tank in about 15 minutes, and got all sweaty from the nic. The thing is unreal, really drinks juice, though.
I actually was at the vape shop today for some juice and an Arctic coil, and was concerned about my iPV4 resistance reading wrong. We put my atty on the owners Snow Wolf. It's pretty cool, connect an atty, press + after it asks if it's new, and it reads resistance and goes automatically to power or TC mode. I didn't use it, but I'm pretty sure that's what he did. It's a nice device. It shows live resistance, so that's why the OP is seeing the resistance fluctuate when hot.Nickel increases in resistance as it heats up, the relationship is mathematically linear, that's why nickel is used in temperature limiting devices. Does the snow wolf have a way to lock in the Resistance when the coil is cold?
I'm yet to try one. Haven't really looked since I got three Smok TCT's. I prefer them all around. I'll pick some up when I order somewhere that has them, at some point, still. I haven't seen them anywhere, though.Where are you guys finding Nickel coils for the Arctic? And are they giving you better coil life than the Kanthal/occ?
The coil may just be over saturated from your priming drips and needs to be vaped for a little while.
There is a little air room left in the tank right? Not filled as much as possible and actually pressing juice out as you screw the base on?
You are in nickel temp control mode right?
What watts or Jules are you set at? I would think at least 50w/j for a 0.25 coil. If they are too low it can't get hot enough and for lack of a better description boils the juice instead of vaporizing it. Same with temp being to low but it's usually watts/joules that are too low.