Coils ohming out higher than before

[NWOVaper]

I bought some fused clapton mediums which were ohming out at .19 when I installed them earlier today, now I go to wick it and it's ohming out at .31 and I didn't even touch them inbetween the jump.. What can I do here?

 

[inspects]

What are they supposed to ohm at?

You using dual or single coil?

 

[NWOVaper]

What are they supposed to ohm at?

You using dual or single coil?

Dual coils, they're supposed to be .20 in dual and originally I got .19 which is fine. I set it aside for a few hours and randomly it's ohming out at .31

Sent from my VTR-L09 using Tapatalk

 

[inspects]

I assume you tried retightening the grub screws?

If your using SS, they have a tendency to loosen due to expansion-contraction, and other factors.

 

[HondaDavidson]

Tighten screws sound like one of the coils it not getting good contact....

Sent from my SCH-I605 using Tapatalk

 

[skt239]

What mod are you using? Do you have another one or an ohm reader to check it on?

 

[entropy1049]

Retighten your post screws.

 

[NWOVaper]

What mod are you using? Do you have another one or an ohm reader to check it on?

I'm using the voopoo drag, tried it on smok procolor and it's the same. Tightened screws, came in at .24 now.

Sent from my VTR-L09 using Tapatalk

 

[skt239]

hmmm you could always try the coils in a different atty. I'd scrap the build all together and start fresh.

 

[NWOVaper]

hmmm you could always try the coils in a different atty. I'd scrap the build all together and start fresh.

Yeah, good idea. I'll try those coils on the drop when I change wicks.


Sent from my VTR-L09 using Tapatalk

 

[skt239]

Yeah, good idea. I'll try those coils on the drop when I change wicks.


Sent from my VTR-L09 using Tapatalk

good luck.

 

[NWOVaper]

good luck.

Changed them into my Drop and it's ohming at .22 consistently. Must be a fault in the combo

Sent from my VTR-L09 using Tapatalk