Cuboid mini help

[Mgk2000]

I've just bought the cuboid mini and have some questions that I couldn't figure out through Google.

What all coils are compatible and what wattage can I run on each one?

What's the difference between the modes, I don't understand why you have different modes if you can adjust the wattage.

Any help is appreciated.

 

[brandon555]

Resistance Range: 0.05-1.5ohm for VT mode
Resistance Range: 0.1-3.5ohm for VW/BYPASS mode

So for temp control mode any coil between .05ohm and 1.5ohm will work, but you'll need to use a resistance wire that is supported like ss, nickel, titanium, etc.

Wattage mode anything .1 to 3.5ohm will work. SS, Kanthal, nichrome, etc

You can run pretty much whatever wattage you want. A lot of coils for tanks will come with a recommended wattage range but its only a recommendation. You can always experiment and find what works best for you.

 

[pizzadave80]

As far as factory coils go...I think the cuboid uses the BF series coils. I would recommend the .2 ohms notch coil. I own a cubis tank, which uses the same coils. The .5 and .6 spit back really bad... and the 1.0 and 1.5 flood alot. I did some reading and the .2 ohm notch is the way to go.

Sent from my SM-G935V using Tapatalk