Do these look like healthy coils?

[Logan Schafer]

I just got this build not even a week ago and this is after I dry burned them.

 

[B-RAD]

Are they heating evenly? If not get them nice and hot then make sure you let off the fire button and squeeze them (with needle nose pliers or strong tweezers)to keep them tight. Also check that your post screws aren't loose.


Sent from my iPhone using Tapatalk

 

[UncleRJ]

Looks good to me!

But do they work?

If they do, you already have the answer!

 

[Logan Schafer]

Are they heating evenly? If not get them nice and hot then make sure you let off the fire button and squeeze them (with needle nose pliers or strong tweezers)to keep them tight. Also check that your post screws aren't loose.


Sent from my iPhone using Tapatalk

They heat evenly sometimes, but that happens with all my builds. About the coils heating unevenly sometimes, do you think it has anything to do with this chip in my contact piece?

 

[B-RAD]

No I wouldn't think so. Electricity takes the easiest path. Usually tightening or straightening fixes this issue. Also if a post screw is loose cause bad connection.


Sent from my iPhone using Tapatalk

 

[Logan Schafer]

No I wouldn't think so. Electricity takes the easiest path. Usually tightening or straightening fixes this issue. Also if a post screw is loose cause bad connection.


Sent from my iPhone using Tapatalk

So should I just tighten all of the screws?

 

[B-RAD]

Just check them to see if they are snug if you over tighten you can break the kanthal


Sent from my iPhone using Tapatalk