1. UP FOR A NEW CHALLENGE? CLICK HERE TO CHECK IT OUT

Don't forget about your preheat settings when pulsing

Discussion in 'What NOT to do!' started by Droogbc, Aug 30, 2018.

  1. Droogbc

    Droogbc Silver Contributor Member For 3 Years

    Blog Posts:
    0
    Joined:
    Aug 22, 2015
    Messages:
    505
    Had a bit of a do'h moment. Was putting a new build in and decided to pulse the first of two coils before installing the second. Mod was still configured for a .1x build, and I was going for higher resistance on the newer build so that single coil was around .5 ohms. Forgot allll about the preheat settings.

    Turned wattage down. Hit fire button. Instaglow. Reduce wattage, hit button, instaglow. Keep reducing all the way to 1 watt, instaglow.

    Then I remembered. Preheat was over 100w for .5 seconds.

    Whoops.
     
  2. SteveS45

    SteveS45 Diamond Contributor Member For 2 Years ECF Refugee

    Blog Posts:
    0
    Joined:
    Mar 25, 2016
    Messages:
    13,544
     
    Droogbc likes this.

Share This Page

Close This Message