Hey everyone,
I've been using my vgod elite mech For a while now and know about battery safety, protruding pins, ressistance and voltage, y'know, the basics. When I went to go dry burn my coils on my mech on the Griffin, it did what I can only assume what is shorting. As a precautionary measure with all new atomizers I get on a hybrid, I always screw the firing switch on slowly to see if anything happens and sure enough the coils started heating like a mofo. The pin on the griffin was adjustable so I adjusted it enough that it was past the 510 threads, but it didn't work...I don't wanna screw with this anymore without proper consultation from multiple people. Does anyone know what I did wrong? Is the pin out too much or too little? Thanks
I've been using my vgod elite mech For a while now and know about battery safety, protruding pins, ressistance and voltage, y'know, the basics. When I went to go dry burn my coils on my mech on the Griffin, it did what I can only assume what is shorting. As a precautionary measure with all new atomizers I get on a hybrid, I always screw the firing switch on slowly to see if anything happens and sure enough the coils started heating like a mofo. The pin on the griffin was adjustable so I adjusted it enough that it was past the 510 threads, but it didn't work...I don't wanna screw with this anymore without proper consultation from multiple people. Does anyone know what I did wrong? Is the pin out too much or too little? Thanks