So I have been using nickel for little while, but not been using a lot, as so soft, it is hard to clean and change cotton out without damaging the coil.
So today decided to pick up some titanium wire, as hear people saying it is easier to work with and tastes better.
But I can't seem to get this stuff to work, watched videos and read up before building, I am using 26 gauge spider titanium wire, doing 8 wraps around a 2.5mm rod, contact coil, 1st tried on my lemo 2, and on the evic-vt would hit temp protection straight away, so no vapor, so then tried it on my IPV4 and that came up with dry coil even though I primed the coil.
So then tried on my kanger subtank with RBA and same thing again, even tried on a dripper and still the same results.
I am setting the resistance, so really lost on what I am doing wrong, can get nickel builds to work, but can't get this titanium working, on verge of giving up and just sticking with Kanthal, but thought I would try the good people of VU before throwing in the towel.
So today decided to pick up some titanium wire, as hear people saying it is easier to work with and tastes better.
But I can't seem to get this stuff to work, watched videos and read up before building, I am using 26 gauge spider titanium wire, doing 8 wraps around a 2.5mm rod, contact coil, 1st tried on my lemo 2, and on the evic-vt would hit temp protection straight away, so no vapor, so then tried it on my IPV4 and that came up with dry coil even though I primed the coil.
So then tried on my kanger subtank with RBA and same thing again, even tried on a dripper and still the same results.
I am setting the resistance, so really lost on what I am doing wrong, can get nickel builds to work, but can't get this titanium working, on verge of giving up and just sticking with Kanthal, but thought I would try the good people of VU before throwing in the towel.