This is my third box mod that I have made using parts from motley mods.
The first was a triple series pwm in a B Hammond box I made for myself, vapes very well.
Second was another b size box with two 18650 in series with the voltmeter integrated into the sled, with a mosfet and led switch.
This is my first g box mod, it’s quite a bit smaller than the first two and much tighter to build in.
I used 14 and 12 ga wire throughout, dual 3034 mosfets, led switch, two 18650 in series.
Voltage drop is very minimal and it hits hard. Doesn’t even get warm with a .3 ohm build, except the attie.
Looking for critiques, what can or should I do differently in future mods, also wanted to show it off as I have a few hours of work in it and I think it turned out well.
The first was a triple series pwm in a B Hammond box I made for myself, vapes very well.
Second was another b size box with two 18650 in series with the voltmeter integrated into the sled, with a mosfet and led switch.
This is my first g box mod, it’s quite a bit smaller than the first two and much tighter to build in.
I used 14 and 12 ga wire throughout, dual 3034 mosfets, led switch, two 18650 in series.
Voltage drop is very minimal and it hits hard. Doesn’t even get warm with a .3 ohm build, except the attie.
Looking for critiques, what can or should I do differently in future mods, also wanted to show it off as I have a few hours of work in it and I think it turned out well.
Attachments
Last edited: