Parallel with 22&28 Gauge Question

[B_noonan]

So I'm trying to figure out roughly what my ohms would read out at if I built a parallel coil using 22 gauge and 26 gauge, I don't have an ohm reader so I just use an istick 20w just to get a close reading. Also I don't have that much 22 gauge left so I don't want to build a coil and have it too low for what I like.

Also, what would it be around if I did a Clapton with 28 around 22

 

[Church3232]

Depends how many wraps and what you wrap around

 

[Church3232]

I'm pretty new at it, but when I'm doing a complicated build like a Clapton or twisted, I usualy just do trial and error. I'll start at maybe 4-5 wraps , then see where it's at as far as ohms, then I'll go back and add or subtract wraps as needed.