OK so I am looking on information on how to tint the glass on a provari. I have seen a few provaris that look like the little glass was tinted. I am looking to see if anyone knows where to buy or better yet if anyone has DIYd it. I am not afraid to take it apart to access the glass or plastic as it likely is. But I am curious if anyone has experience doing this or can point me in the direction of someone who has. Wondering if a small bit of auto glass tint would do the trick. OK so how say you? Got pics?
Become a Patron!
Provari glass tint?
- Thread starter TruckCentral
- Start date
I would tape the whole mod off, use an exacto knife to cut the masking away from the led lens, and spray it with this stuff:
http://www.autozone.com/autozone/ac...Black-lens-tint/_/N-255s?itemIdentifier=87705
just make sure to do a good job with you prep work and tape job and you should be ok. I have not tried it myself on a mod, but I have used it on tail lights to get a slightly smoked look. If you go crazy you will end up with a near black finish that may not let much light through.
http://www.autozone.com/autozone/ac...Black-lens-tint/_/N-255s?itemIdentifier=87705
just make sure to do a good job with you prep work and tape job and you should be ok. I have not tried it myself on a mod, but I have used it on tail lights to get a slightly smoked look. If you go crazy you will end up with a near black finish that may not let much light through.
http://vapingunderground.com/threads/alcohol-ink.3054/
There is a vid in this thread, looks like you could use this stuff.
There is a vid in this thread, looks like you could use this stuff.