If I understand correctly, you have the Pink Samsung cells which have 5A CDR (Continuous Discharge Rate). First I would recommend getting better batteries. You would not be able to push those batteries too hard. You would be forced to stick within the realm of 1.0+ohms to be safe.
Your wattage would be limited by your build with these batteries. At 50W you would need a minimum of 0.5ohm to stay within the 10A limit, and you couldn't exceed those 50Ws (to get 100W out of these batteries would require a 1.0ohm build). If you had 20A CDR cells, you could run a 0.25ohm build at 100W. To achieve this mods limits (100W @ 0.15ohm) would require cells with 25A+ CDR.
Knowing Battery Safety is the most vitally important thing in vaping when you start building. I would recommend studying up on Ohms Law and Battery Safety (
www.steam-engine.org), and getting a set of, say, VTC4s (30A CDR) if you want to be able to use your mod to it's fullest potential without having to worry about the batteries limits anymore, the VTC4s will handle anything the mod will throw at it (within the mods ohm limits of 0.15ohm - 5.0ohms).
Unfortunately I can't safely recommend building anything with those particular batteries in this mod, because of the potential for disaster (I could recommend a decent build to be used at 50Wmax, but if you were to accidently forget it's only 50Wmax, turn it up to 75W, you could now have a terrible accident). If you insist on using these batteries, I would recommend building a basic 1.0ohm coil, at least that way you could turn it up to 100W and still be within the batteries limits, other than that, there's too much chance for an accident to occur to recommend any actual builds.