Wismec rx 2/3 & Herakles pro

[M0tionn]

Just bought the Wismec Rx 2/3 and Herakles pro and got it all set up but I am unable to adjust my wattage it sticks to 18.7 W and 6.00 V any ideas?

 

[M0tionn]

Edit: When tank is not on I can change wattage

 

[nightshard]

Seems the resistance of you coil is too high, either because the coil itself has high resistance or because of a conductivity issue along the way.

 

[EB063]

Same problem here, I'm currently using a Wismec rx2/3 with Herakles pro tank (1.8 ohms coils). The highest wattage I can adjust to is 19.6W (6.00 V) Tried the same tank with an IPV4S and it went way further than 19.6W. Please help.

 

[Paratech]

maximum output voltage is 6V and 9V respectively.
6V for 2 cell, 9V for 3 cell.
http://www.wismec.com/product/reuleaux-rx23/

To get higher wattage you'll need lower resistance.

 

[SirRichardRear]

maximum output voltage is 6V and 9V respectively.
6V for 2 cell, 9V for 3 cell.
http://www.wismec.com/product/reuleaux-rx23/

To get higher wattage you'll need lower resistance.

this^
it's working as intended. the mod won't do more watts then that unless you use a lower resistance coil or use the 3rd battery.

but to be honest with a 1.8ohm coil thats way too much wattage. with that coil 3.0 to 3.7 volts is the right spot

 

[EB063]

Thanks @SirRichardRear & @Paratech for the helpful comments!