ivp 3 li battery tray

[larrys1967]

Hi, I need a new battery tray for my IVP 3 Li p4u , any ideas?

 

[Markw4mms]

You might try contacting P4U service and see if they sell one as a replacement part. Other than that, maybe see if you can find someone with a dead mod that might sell you one. One other thing, you might see if you could get one 3-D printed for you.

 

[James]

if you can draw it up in www.tinkercad.com it can be printed .
you could take the sled from this http://www.thingiverse.com/thing:1329556 or this one
http://www.thingiverse.com/thing:739601
http://www.thingiverse.com/thing:578977
http://www.thingiverse.com/thing:633030
and put it in to tinkercad and mess with it till it fits .

 

[James]

If you look up your local library thay may have a " MakerSpace "
That is a place that has 3D printers that anyone can use . All you have to pay for is the fillament , and clean up
after your self . Fillament is very cheap .

 

[Huckleberried]

Moved to Battery Junkies

 

[larrys1967]

You might try contacting P4U service and see if they sell one as a replacement part. Other than that, maybe see if you can find someone with a dead mod that might sell you one. One other thing, you might see if you could get one 3-D printed for you.

Thanks Mark, I'm going to try these ideas!

 

[larrys1967]

if you can draw it up in www.tinkercad.com it can be printed .
you could take the sled from this http://www.thingiverse.com/thing:1329556 or this one
http://www.thingiverse.com/thing:739601
http://www.thingiverse.com/thing:578977
http://www.thingiverse.com/thing:633030
and put it in to tinkercad and mess with it till it fits .

Thanks Mark,this is pretty cool !I'm going to check this out !

 

[dr_rox]

Hi, I need a new battery tray for my IVP 3 Li p4u , any ideas?

That tray, if we're talking about the ipv3 li, has issues tearing battery wraps.
Also, the tray appears to be a tub in a deck.
So, assuming you have the tools and have taken the thing apart and checked it out... consider dremeling out the old tray and using a keystone.
But....
What is wrong with the old tray. Got any pix?
There may be a way to rebuild what was there, better.

 

[suprtrkr]

+1, I'd go with a Keystone if I could shoehorn it in there. Or print one.

 

[larrys1967]

That tray, if we're talking about the ipv3 li, has issues tearing battery wraps.
Also, the tray appears to be a tub in a deck.
So, assuming you have the tools and have taken the thing apart and checked it out... consider dremeling out the old tray and using a keystone.
But....
What is wrong with the old tray. Got any pix?
There may be a way to rebuild what was there, better.

I put a battery with a bad wrap on it,it melted the sled and pushed the contact thought the hole.

 

[larrys1967]

+1, I'd go with a Keystone if I could shoehorn it in there. Or print one.

thanks, i might try that.