Will the 30Q's work well with the RX200? If not, why not?
Become a Patron!
Samung 30Q's and the RX200...
- Thread starter Adenrele1982
- Start date
What resistance is your coil and what wattage do you intend to run? I use the lg hg2 3000 mAh 20A or the lg he2 2500mAh 20A in my rx200.
@Mooch tested this battery a while back and rated it good to 20 amps if I remember it correctly. That takes it up to 170 watts in a 3 battery mod.
Most people don't vape at 170 watts too often and if that's you you should find it pretty good. OTOH, if you want to vape at 200 watts or more you might find a higher amp rated battery will be better for you.
Thanks Ryedan!
I doubt I'll take it past 75w, really. Does this mean I should get a 10Amp or 15Amp battery, to get the most out of the battery? If so, do you have any 10Amp or 15Amp battery recommendations? Thanks, again.
I ordered a .25 and .5(SS) for my Uwell.
I ordered a .9(Kanthol) and .5(SS) for my Gemini.
Anywhere from 35watts to 75watts... I may try 100watts just to have the experience, but that won't be the norm.
Thanks, Froggie!
I am running a griffin rta on my rx200 with a duel coil build of .16 ohm and I generally have my wattage between 50-60 watts, but I like a cool vape. I would not top it out over 80 watts though with my build. Here is the link to the steam engine battery drain calculator. Find your battery in the battery preset on the left and enter your resistance. And select regulated (APV). It will tell you what a single battery will do. Also click on how it works below the battery info for some great info.
http://www.steam-engine.org/batt.asp