IPV5 and Crown Ni200 .15 coils - low resistance

[plants]

I cannot get my IPV5 to fire the Ni200 .15 coils. I put it on another mod and the coil is registered at .15/.16 but as soon as I use the IPV5 and try to set the resistance it is at .002 and will not let me adjust it.

I have had success with the SS coils but they do not fire very hard on SS304 mode so I usually end up using Ni mode and turn the temp down. Is there a manual TCR I can use with those? I have read about the the numbers but do not understand what to set it to for a .25 coil.

Help me out - I love both and want them to play nice together!

 

[Deucesjack]

Are you re setting the resistance when you attach the atty? I run Crown ni200 on my IPV5 everyday.

 

[Marc411]

Same here, make sure you have it set to Joules and press the up and down button at the same time to set the coil resistance.

I just made the same mistake the other day, had it set to wattage and got low resistance.

 

[skt239]

For the Ni200 coils try the TCR value 600

 

[plants]

OK to respond, if I press both buttons I should be able to set the resistance - but all it does it sit at .002 and I cannot get it to change. Even the stainless I can change the resistance .25-.30 depending on temp but as soon as I enter this ode with the Ni200 it won't let me adjust it.

So my problem with the TCR mode - it is nothing near 600 it is like 0.00300 - do you mean set it to 0.00600?

 

[skt239]

OK to respond, if I press both buttons I should be able to set the resistance - but all it does it sit at .002 and I cannot get it to change. Even the stainless I can change the resistance .25-.30 depending on temp but as soon as I enter this ode with the Ni200 it won't let me adjust it.

So my problem with the TCR mode - it is nothing near 600 it is like 0.00300 - do you mean set it to 0.00600?

Sorry about that. Try 0.00620

https://www.djlsbvapes.com/different-wires/