Become a Patron!

Evic VTC Mini - SS / Ti Mode Gone After Updating - Issue Resolved

skt239

skt239

VU Donator
Platinum Contributor
Member For 4 Years
Hello all,

Today I finally upgraded my Evic VTC mini to the latest software and everything seemed fine. Then just a few minutes ago, I went to go use it and found my setting for stainless had vanished... Now Ti is gone too. WTF? I could give a shit about the Ti being gone but I need my 316L setting. Has any had this happened to them? I'm going to reload the old software and hopefully that brings it back. It's just very strange as I have not heard of it happening to anyone else.
 
Neunerball

Neunerball

Platinum Contributor
Member For 4 Years
Member For 3 Years
ECF Refugee
I haven't had this happen. However, I'd try downloading the upgrade and re-installing it on the VTC.
 
skt239

skt239

VU Donator
Platinum Contributor
Member For 4 Years
Neunerball said:
If I remember correctly, the mod needs to be powered on.
Click to expand...

I've tried it with the mod on, off, batteries in and out. I'm sure others have had this issue I just need to do some searching. Thanks for the response.
 
skt239

skt239

VU Donator
Platinum Contributor
Member For 4 Years
BatteryConserver said:
It's not gone, the menu is structured differently now.
Only found a german Video, it starts at minute 04:00

Or search the forum, there is a Tread
Click to expand...

Holy shit you are right! Thanks a lot dude, you are a life saver. All is well with the Evic.
 
You must log in or register to reply here.

VU Sponsors

Top