Ipv5: lower than the minimum resistance?

[Qlippoth]

So I built a coil earlier for my ipv5 and ended up miscalculating the length of my wire. Long story short, the resistance ended up at .13.

I read online that the minimum resistance for power mode is .15 but my coil is working. Any idea what's going on? Shouldn't it have just showed the low resistance error?

Sent from my H220 using Tapatalk

 

[BoomStick]

Don't have an answer that isn't a wild ass guess, but I personally wouldn't run a Chinese board at the very edges of it's limits. Just rebuild a little higher.

 

[Slurp812]

Its specification is 0.15. What it will actually do is a different story. Like everything else, close enough for rock -n- roll!

 

[Qlippoth]

I guess I'm rebuilding.

Sent from my H220 using Tapatalk

 

[PaulS]

Put it in TC - go to TI - set at lowest temperature. Vape at comfortable joules.

 

[Qlippoth]

Put it in TC - go to TI - set at lowest temperature. Vape at comfortable joules.

? Even when using kanthal nichrome?

Sent from my H220 using Tapatalk

 

[PaulS]

yes.

 

[Qlippoth]

yes.

Okay but yeah I just rebuilt. Thanks anyway!

Out of curiosity, won't the vape be very different if I fired it in ti tc mode?

Sent from my H220 using Tapatalk