Ohm freeze

[xJoseph]

Hi to all. I am using my limitless RDTA+ and put a new build in it (normal clapton)
And I put it into my ohm reader and it ohms out at 0.06 which is not possible considering I have been building coils for years. I tried puttinh new build in it still ohms out the same in the ohm reader AND my various boxmods (RX200 and some other stuff) Is there any particular reason to this? And can I fix this problem?

Sent from my SM-A510F using Tapatalk

 

[BoomStick]

Completely disassemble, clean and inspect. Every single part. You'll find the problem. We can only make wild ass guesses.

 

[PaulS]

Inspect the 510 first. See if it is seated properly. That is often the problem.

 

[UncleMike]

also check the post holes to make sure there's no left over wire clippings stuck inside

 

[Dutch0hms]

Inspect the 510 first. See if it is seated properly. That is often the problem.

Sounds like a problem with the 510 or u have to tighten ur postscrews.

 

[LuTang]

yes to all of those. check all screws. makes sure posts are all secure. check for wire clippings.

 

[SirRichardRear]

Completely disassemble, clean and inspect. Every single part. You'll find the problem. We can only make wild ass guesses.

this^ it'll solve any problem. instead of wildly trying to pin point, it's much easier to take it apart, clean it, and reassemble. should be less then 5 mins to do that and it should work fine after