FUCHAI 200W OWNERS

[ej1024]

I have had a Fuchai 200w TC mod over a year and the TC function just got squirrelly. It only pulls for a second or two then quits. Batteries are new and fully charged and I cleaned all the contacts. It works fine in wattage mode but I like TC because I can get 6 months out of my Ti RBA build.

Any ideas on what is wrong? My assumption is the TC chip is going bad.

Invest on a fsk,DNA,yihi device

 

[skt239]

I have had a Fuchai 200w TC mod over a year and the TC function just got squirrelly. It only pulls for a second or two then quits. Batteries are new and fully charged and I cleaned all the contacts. It works fine in wattage mode but I like TC because I can get 6 months out of my Ti RBA build.

Any ideas on what is wrong? My assumption is the TC chip is going bad.

What atty are you using ?

 

[mtwhickory]

What atty are you using ?

I already ordered an HCigar VT133 with DNA. I didn't mention it earlier because it has nothing to do with my question.

Don't know what an atty is.

 

[ej1024]

Lol

 

[skt239]

It's the thing on top of your mod...

 

[Teresa P]

Lol! In his defense, I haven't used the terms "atty" and "clearo" since I chucked the ce4s two years ago. It's a TANK, man....

 

[mtwhickory]

I am currently using a Kanger SubTANK Mini with a .18ohm titanium coil. Since the TANK works in wattage mode and worked perfectly in TC for over a year until 2 days ago, I doubt it is a TANK problem.

When the VT133 gets here I will put the same tank on it to verify.

 

[skt239]

Did not mean any offense by my post.

 

[mtwhickory]

No offense taken. I just assumed you were British.

 

[Teresa P]

Long as no one refers to any piece of gear as a "vape thingy," I'm good. I've actually heard people say that and makes me think "If that's all you know about it, you're not ready to own one."

 

[mtwhickory]

Ok. I got the Hcigar VT133 today but I can't get it to work well. I keep getting burnt taste or ohm too low message. This thing is much more complex than my Fuchai 200. Do I need to set this up with the software?

Does anyone know of a dedicated VT133 thread where I can post questions?

 

[mtwhickory]

My Kanger Sub mini with Ti coil originally showed .18 ohms on the tester. On the VT133 it shows .28 ohm. The coil is about 2 weeks old and should have months of life left.

 

[mtwhickory]

My Kanger Sub mini with Ti coil originally showed .18 ohms on the tester. On the VT133 it shows .28 ohm. The coil is about 2 weeks old and should have months of life left.

I built a new Ti coil with 7 wraps which now shows .35 ohms. So far, it is working fine on TC mode with the new HCig vt133. The Fuchai 200 still doesn't work in TC mode with this new coil. This leads me to believe the chip has gone bad on the Fuchai.