Become a Patron!
Loose top on azeroth
- Thread starter Artdragon
- Start date
SirRichardRear
AKA Anthony Vapes on Youtube
VU Donator
Diamond Contributor
Member For 3 Years
Reviewer
Oooh, so it might actually be authentic, sweet
Sent from my SM-G900P using Tapatalk
gopher_byrd
Cranky Old Fart
VU Donator
Diamond Contributor
ECF Refugee
Member For 5 Years
VU Patreon
Something you can try is put a strip of dental floss in the o-ring channels then put the o-rings on top of the floss. It might be enough to hold onto the cap.
Torturedzen
Member For 4 Years
I love my Azeroth! My cap was loose also so I put a slightly larger o-ring in the top grove which made the cap nice n tight.
The downside was removing it was a major bitch. Going to try the dental floss suggestion.
The downside was removing it was a major bitch. Going to try the dental floss suggestion.
Hmmmm !,
Dental floss could solve a couple of my " loose cap " dilemma's.
Of course thicker ( or newer ) "O" rings would be bestist me thinks.
On a side note I have an authentic Tsunami and it takes the wife holding the mod and myself on the atty end , both pulling to get that top cap off , may have exaggerated a tad there but you get the picture .
Dental floss could solve a couple of my " loose cap " dilemma's.
Of course thicker ( or newer ) "O" rings would be bestist me thinks.
On a side note I have an authentic Tsunami and it takes the wife holding the mod and myself on the atty end , both pulling to get that top cap off , may have exaggerated a tad there but you get the picture .
SirRichardRear
AKA Anthony Vapes on Youtube
VU Donator
Diamond Contributor
Member For 3 Years
Reviewer
Yeah geekvape always have tight orings. Just put a little juice on themHmmmm !,
Dental floss could solve a couple of my " loose cap " dilemma's.
Of course thicker ( or newer ) "O" rings would be bestist me thinks.
On a side note I have an authentic Tsunami and it takes the wife holding the mod and myself on the atty end , both pulling to get that top cap off , may have exaggerated a tad there but you get the picture .
Sent from my SM-G935V using Tapatalk
What mm o-ring did you use? I'm looking at kidney puncher and going to get some orings. They have 10mm, 15mm, 16mm and 18mm. I may just get each size since they're so cheap. Gotta make sure they're 24mm in diameter tho
Sent from my SM-G900P using Tapatalk
It worked, btw. Thank you so much for the suggestion!
Sent from my SM-G900P using Tapatalk
Torturedzen
Member For 4 Years
>>What mm o-ring did you use?<<
Not sure. I've collected a butt-load of o-rings since I began vaping almost 3 years ago. I just found one that looked like the same diameter and slipped it on there. It was a bit beefier than the original tho.
Not sure. I've collected a butt-load of o-rings since I began vaping almost 3 years ago. I just found one that looked like the same diameter and slipped it on there. It was a bit beefier than the original tho.