Dual coil atty, want to make single coil builds, HOW?

[z3pHy2]

So, i'm currently using the RBA head for the SMOK TFV8 baby beast. It's a velocity styled two post deck, designed for dual coil setups.
That means, it has two sets of juice holes, and two air holes. This is the deck.
https://www.fasttech.com/product/5445500-authentic-smoktech-smok-tfv8-baby-replacement-rba

I want to make a single coil build on that, was wondering if anyone here has tried/succeeded in doing something like this.
The obvious doubt here is, if i have only one coil and i wick it with only one set of the juice holes, the second set of juice holes would flood into the atty. Secondly, the airflow.
While doing some research i found that the Avocado, comes with a moulded ceramic block that plugs into the extra juice and air holes to allow the user to make a single coil build.
I'm hoping there's some hacky way to achieve the same on my RBA head.

TIA

 

[bobnat]

Here you go. I do this with my OBS engine. Though your deck is smaller you should be able to do it.

I've got one just like yours that just left the main post office and should be here tomorrow.

 

[IMFire3605]

So, i'm currently using the RBA head for the SMOK TFV8 baby beast. It's a velocity styled two post deck, designed for dual coil setups.
That means, it has two sets of juice holes, and two air holes. This is the deck.
https://www.fasttech.com/product/5445500-authentic-smoktech-smok-tfv8-baby-replacement-rba

I want to make a single coil build on that, was wondering if anyone here has tried/succeeded in doing something like this.
The obvious doubt here is, if i have only one coil and i wick it with only one set of the juice holes, the second set of juice holes would flood into the atty. Secondly, the airflow.
While doing some research i found that the Avocado, comes with a moulded ceramic block that plugs into the extra juice and air holes to allow the user to make a single coil build.
I'm hoping there's some hacky way to achieve the same on my RBA head.

TIA

Use some cotton to block the second set of juice inlets and block the second air hole at the bottom. You'll get some air restriction as you are blocking off one air hole from the inlet, making a tighter draw and may warm the vape up a bit.

 

[z3pHy2]

Wew, that almost looks doable. Though i still have my worries about it leaking and what not, it's definitely worth a go.
Thanks @bobnat and @IMFire3605