I completely disagree that 36g alien wrap wire adds too much mass for a mech. Using 27g Nichrome 80 for the 3 cores and 36g Nichrome 80 for the alien wrap wire works absolutely fabulous on a single battery mech if going for a .11 ohms dual coil build at 4.5 wraps, 2.5mm inner diameter. Famous coil builder m.terk also builds aliens the exact same way, and, he keeps selling them like hot cakes BTW. Nichrome 80 still also heats faster than SS 316L. Depending on what you are looking for, Nichrome 90 might actually be a little bit too hot if using a Samsung 30T battery. So it all simply boils down to your own personal preferences. Finally, the optional copper square posts from Kennedy are not needed IMO. All it takes to properly mount the coils into the round post holes is that tiny bit of extra patience and careful practice. That plus the fact the stainless steel posts require virtually no effort when it comes to keeping them always perfectly clean.
i like 2~ 3 secs drags of hot vape, there IS a diff in ramp up time between 36 to 40/44
i do sub 0.1 most of the time (.08 normally), again, pulse drags in the 2 ~ 3
the setup i describe ramps up FAST
the square posts do make a difference, i instantly notice that extra hump when i upgraded my ruby v1 from ss post to the square ones, the connection (and material) at the coils themselves is another point of voltage drop
Nichrome 90 i mentioned because it does ramps faster than SS and (i believe i noted) I just PREFER (myself) the taste of it vs SS
an above .1 ohm (it's about .11~.12) coil i have been using is 5wraps of 2x26N90 claptoned with 40N90. I can comfortably wrap with 44g as well but havent found a supplier of N90 at that gage (n80 i do have plenty, doesn't taste the same)
@ephrain, PM me and i'll send you a pair of these when I get to usps