Coils

[floresroach]

So I've been using a parallel coil setup on my DOGE RDA and my god it's getting hot. I understand that it's running as if there were 4 coils. So I want to decide to back off and run regular coils. For the life of me, I can't remember the size of the screwdriver to use to make them or the number of full loops to do.


Sent from my iPhone using Tapatalk

 

[dre]

What ohm are you looking for? You can use steam-engine.org to find the build your looking for. Or just say on here I'll do my best to help.

 

[nightshard]

http://www.steam-engine.org/coil.asp

 

[floresroach]

Don't want to go lower than .19. My batteries are 3.7V AWT brand 2500Mah 35A.


Sent from my iPhone using Tapatalk

 

[OB61887]

I prefer macro coils on the 3mm screwdriver, but that is a preference. As far as I'm concerned though, the larger the diameter the better when using 24 gauge or less.

 

[Dalton801]

I usually do a 4 full wraps on a 2.4mm screw with 24g kanthal, dual coil of course. But I beleive it comes out to .27 ohms? Also, get your hands and some Imren batts, friends.
They last me all day!

 

[MKPM]

7 wraps of 22g on a 1.5mm mandrel will yield .19 oms (dual). That is my sweet spot build on all of my drippers as well as my Orchids.

 

[floresroach]

7 wraps of 22g on a 1.5mm mandrel will yield .19 oms (dual). That is my sweet spot build on all of my drippers as well as my Orchids.

Thanks, lot's of good input here, very much appreciated.


Sent from my iPhone using Tapatalk