Unflavored nicotine

[sgibby88]

Hopefully I'm in the right spot and don't get flamed for this post. The significant other decided she wanted to start vaping even though she's not a smoker. I used vaping to get me off them stickies. My question is what's a good site to get unflavored nicotine from as some of the juices we purchase we end up with doubles one with nic and one without. I'd rather save some money on them purchases and just split a bottle since I actually go through my juice. We're as she has quite a few she hasn't finished I could just add nic to my level and vape away. Being this stuff adds up quick I'm not trying to waste any money and save were I can. Especially being that's one of the reasons I quit stinkers. 8 bucks a pack and 2 a day gets pricey.

Also what's everybody use to mix the stuff. Beakers or a special measuring cup?? And info and help would be greatly appreciated thanks for your time and sorry about the book

 

[Smoky Blue]

http://www.ecigexpress.com

i think they are starting to put mix kits together, but.. they have good nic and pg/vg
might want to check them out..

also http://wizardlabs.us/

and they have various parts you might find helpful

 

[Smoky Blue]

Also what's everybody use to mix the stuff. Beakers or a special measuring cup?? And info and help would be greatly appreciated thanks for your time and sorry about the book

i mix in bottles, gradient cylinders, or beakers.. just depends on where i am and what i have to work with..

hope this helps out.. and good luck.. post up if you get lost..

also you will need a good calculator:

http://www.vitalsparks.com/ez-mix.html

does cost etc..

 

[sgibby88]

Thanks again. I figured I would pick some nic up her juices don't go to waste since I do like quite a few of them. And being there's only a tank or 2 out of them I'll add some nic and get my money's worth. Don't wanna see the stuff go bad

 

[TheVapingDevil]

If you are only going to be adding nicotine to the existing bottle at 0 then your supplies will be minimal. When you start mixing flavors and additives for your own mix does it get extensive


Sent from my iPad using Tapatalk

 

[sgibby88]

All I'll be doing is turning a 0 into a 3. Starting to get confused a little bit now. Guess this is were I look for a good calculator. Easy calculation if I was dealing with 100ml of a flavor instead of 15 or 30ml lol

 

[TheVapingDevil]

In my opinion you will a syringe with at 14 gauge needle. Lure locks work great. Then your nicotine. Safety gloves will
Be a great and necessary asset for you. Download a juice calculator such as ejuicemeup. That will tell you how much nicotine you will need to add based on the strength and the amount in your bottle. For example I use 100mg nicotine and I mix my juice at 3%. So I only use .9ml of nicotine to get my desired percentage for a 30ml bottle. If you need help all of us are here to help.


Sent from my iPad using Tapatalk

 

[sgibby88]

Thanks again. As of now I'll be ordering the supplies needed and I'm sure I'll be back with more stupid questions. Thanks for your patience

 

[efektt]

Dont forget the syringe and the needle tip!

 

[sgibby88]

That's on the list. As well as gradient cylinders and a 120ml bottle of 3mg nic

 

[efektt]

That's on the list. As well as gradient cylinders and a 120ml bottle of 3mg nic

You are going to want a higher strengh.. the stronger the nic, the less you will need to add, and will cause the least amout of weaking the flavor. Get some extra bottles as well.

 

[sgibby88]

What would you recommend then? Like a 24 or go up to like 100? I've been saving my smaller 15 and 20ml bottles for when I go to work so I don't have to lug around a 30ml. After a few weeks I'll chuck one and use a newer one

 

[efektt]

What would you recommend then? Like a 24 or go up to like 100? I've been saving my smaller 15 and 20ml bottles for when I go to work so I don't have to lug around a 30ml. After a few weeks I'll chuck one and use a newer one

Its all what you feel comfortable with. With 100 you would be adding the least amount.... and would alter the flavor the least, but it is more toxic and mistakes are going to have a bigger inpact. With 100mg, you would add .45ml to 15ml to get a 3ml juice. Most people dont start with 100. Maybe get a small bottle of 24 until you get comfortable and then go from there?

 

[Heabob]

I just get the 100 and cut it in half for double the quantity.
Saves on the shipping, etc.
100 is usually more economical.
Just wear gloves if using the 100, and mix it by/in the sink for safety.
You can also put some of the 100 in smaller 15ml or 30ml dropper bottles for easier handling.

 

[sgibby88]

Quick question. If I have a juice that's a 0 nic and want to make it a 3 based on 15ml would I add 1.88 ml of nic at a 24mg base? When I put the juice specs into a calculator I get a message that states it is not feasible. This is rather confusing. I tried the vital sparks link and am confused by it. So I'm on steam engine calculator

 

[efektt]

Quick question. If I have a juice that's a 0 nic and want to make it a 3 based on 15ml would I add 1.88 ml of nic at a 24mg base? When I put the juice specs into a calculator I get a message that states it is not feasible. This is rather confusing. I tried the vital sparks link and am confused by it. So I'm on steam engine calculator

2 ml of 24 nic and 14 ml of 0 mg juice will give you 16ml of 3 ml juice.