IPV4 joules resistance stettings

[wllmc]

how the heck do I set the resistance on this this ! I accidentally did something and my resistance went from 0.05 and changed to 0.15 I pressed both small buttons down at the same time and it says set resistance but as soon as you let go it turns off. ... maybe I just need to tighten the screws down inside ? its on a kayfun so if so forget it I'lll do it in a couple days lol. to lazy for all that right now. any advice would be great !

 

[Huckleberried]

Have another cup of coffee. That's my advice. I'll join you.

 

[wllmc]

Have another cup of coffee. That's my advice. I'll join you.

ha ! ok done, cheers !

 

[rdsok]

how the heck do I set the resistance on this this ! I accidentally did something and my resistance went from 0.05 and changed to 0.15 I pressed both small buttons down at the same time and it says set resistance but as soon as you let go it turns off. ... maybe I just need to tighten the screws down inside ? its on a kayfun so if so forget it I'lll do it in a couple days lol. to lazy for all that right now. any advice would be great !

I believe that is the Ω reading it took at the time you pushed the buttons and then it uses that reading to calculate until it is reset.

The temp of both the device and the atomizer needs to first be stable... so let both cool all of the way down. Next set the resistance again once the temps are stabilized.

If you feel the resistance it is reading is in error... clean your 510 connection, the threads and post on the atomizer and you may also want to make certain the screws on the coil didn't loosen up. Then repeat the process to let the temps stabilize and set the resistance again.

 

[Neunerball]

I believe that is the Ω reading it took at the time you pushed the buttons and then it uses that reading to calculate until it is reset.

The temp of both the device and the atomizer needs to first be stable... so let both cool all of the way down. Next set the resistance again once the temps are stabilized.

If you feel the resistance it is reading is in error... clean your 510 connection, the threads and post on the atomizer and you may also want to make certain the screws on the coil didn't loosen up. Then repeat the process to let the temps stabilize and set the resistance again.

+1